Pipe Bending Machine Structure

Oct 06, 2024

Leave a message

(1) BENDING DIE
Installation: a. Remove the die fixing nut (FIG-7(1)) in a counterclockwise direction. b. Insert the die and tighten the die fixing nut.
(2) CLAMP DIE)
Installation: a. Pull out the clamp fixing centering shaft (FIG-7 (2). b. Put the clamp in and then insert the fixing centering shaft.
Adjustment: a. Loosen the clamp seat fixing (FIG-7 (3), then put the control panel into manual mode, press the clamp tube button (FIG-7 (3)) to the end of the clamp path. (At this time, there must be a gap between the wheel mold and the clamp, which can be adjusted by the clamp seat adjustment screw (FIG-7 (4)).
b. Adjust the clamp seat adjustment screw (FIG-7 (4)) to make the clamp and the wheel mold fit completely.
c. Press the clamp back button (FIG-4 (6) to retract the clamp, and then turn the clamp adjustment screw (FIG-7 (4)) clockwise about 1/2-1/4 turn.
d. Tighten the clamp seat fixing nut (FIG-7 (3).
(3) Guide mold (PRESSURE DIE)
Installation: a. Remove the guide die fixing screw (FIG-7 (8) and then insert the guide die.
b. Tighten the guide die screw.
Adjustment: a. Loosen the guide die seat fixing nut (FIG-7 (5), then put the control panel into manual mode, press the clamping button (FIG-4 (3) to the end of the guide die path (at this time, there must be a gap between the wheel die and the guide die, which can be adjusted with the guide die adjustment screw (FIG-7 (6)).
b. Adjust the guide seat adjustment screw (FIG- 7 (6) Make the guide die and wheel die fit completely.
c. Press or unclamp button (FIG-4 (6), and then turn the guide die adjustment screw (FIG-7 (6) clockwise about 1/2-1/4 turn.
d. Then tighten the guide die seat fixing screw (FIG-7 (6).
(4) Mandrel
Installation: a. Insert the mandrel into the through rod in a clockwise direction.
b. Then tighten the mandrel fixing screw (FIG-7 (8).
(Please note that the mandrel must match the bending direction of the bend)