Pipe Bending Machine Operating Procedures

Oct 08, 2024

Leave a message

Before operation
1. The machine tool must be well grounded, and the wire must not be less than 4mm2 copper soft wire. It is not allowed to connect to the power supply voltage exceeding the specified range, plug-in and unplugging of plug-ins with power on, and megohmmeter cannot be used to test the control circuit, otherwise the device may be damaged.
2. When plugging and unplugging connectors, do not pull the wires or cables to prevent welding from pulling off.
3. Approach switches, encoders, etc. cannot be hit with hard objects.
4. Do not hit the display unit with sharp objects.
5. The electrical box must be placed in a ventilated place and is prohibited from working in dust and corrosive gases.
6. It is not allowed to add or reconnect the PC input and output terminals privately.
7. When changing the power supply of the machine tool, the motor direction must be reconfirmed.
8. The machine tool should be kept clean, and special attention should be paid to the fact that there should be no foreign matter in the sliding grooves such as clamping blocks and sliders.
9. Lubricate the chain and other sliding parts regularly.
10. The power supply must be disconnected during cleaning and maintenance.
11. Preparation before driving: Check whether the oil level in the oil tank reaches the oil level line, add oil to each lubrication point, start the machine to confirm the direction of the motor, check whether the oil pump has any abnormal sound, and check whether the hydraulic system has any oil leakage after starting the machine (the angle encoder is in a state where refueling is not allowed);
12. Pressure adjustment: Use the electromagnetic overflow valve to adjust the pressure to ensure that the system pressure reaches the required working pressure, which is generally not higher than 12.5Mpa.
13. Mold adjustment: Mold installation requires the mold to be centered with the clamping block, and the clamping block can be adjusted with bolts; the booster block is centered with the mold, and the booster block is adjustable; the core head is centered with the mold, loosen the core head frame bolts, and tighten the bolts after adjusting the center.
During operation
1. When the machine tool is started, pay attention that the human body must not enter the range swept by the rotating arm.
2. When the machine tool is working, all personnel are prohibited from entering the space swept by the rotating arm and pipe fittings!
3. The hydraulic system of the machine tool uses YA-N32 ordinary hydraulic oil (original brand No. 20), which is normally replaced once a year, and the oil filter must be cleaned at the same time.
4. When adjusting the machine tool (mold), the adjuster should press the button to adjust it. Never adjust it on the machine tool by one person while the other person operates on the control cabinet.
5. The core rod should be removed when adjusting the machine tool or driving an empty machine.
6. The pressure of the hydraulic system should not be greater than 14Mpa.
7. When manually adjusting the speed of the side push cylinder, the arm should be rotated to ≥900 for adjustment. The adjustment speed is synchronized with the linear speed of the edge of the rotating pipe bending mold. It is forbidden to push the side push speed faster than the linear speed of the rotating mold edge in the manual state.
8. Generally, the tension of the chain should be checked after the machine has been used for a period of time to keep the upper and lower chains consistent.
9. In the core bending mode during automatic operation, before the bending arm returns, the operator must ensure that the core head is inside the pipe, or ensure that the core shaft is not blocked when the bending arm returns, otherwise, the core head or core rod may be bent or broken.
3. After the work is completed, cut off the power supply and do a good job of cleaning and lubrication.