Pipe cutting machine operating procedures

Oct 13, 2024

Leave a message

1. Inspection before starting the machine
1.1 Check whether the saw blade is intact. If there are nicks or cracks, it should be replaced.
1.2 Replace the corresponding positioning pins and guide sleeves according to the specifications of the high-pressure hose.
2. Operation steps
2.1 Turn on the power and start the motor.
2.2 Insert the cut high-pressure hose into the replaced guide sleeve, pull the knife-shaped handle to drive the hose into the saw blade, and the hose will be cut. When the slide is reset, it will be pulled back to its original position by two tension springs.
2.3 Insert the inner hole of the cut hose into the positioning pin shaft. When the saw blade rotates, a slit is cut at the place where the rubber is to be stripped to ensure that a good rubber-breaking effect is achieved when the rubber is stripped.
2.4 After work, the power must be turned off.